SolarGaps SGV1C80-10-R Series, Руководство по эксплуатации

Страница: 16 / 45

EN.16
7. Product installation
7.1.
General sequence of operations for installation of the BLINDS is as follows:
install and fix the cornice that contains properly fixed casing with electric motor,
mechanisms and control unit with the help of latch brackets;
insert guiding rollers of slats with solar panels into slotted side guides;
install the slotted side guides and fix them with mushroom brackets;
drill holes for electrical cables;
install indoors and properly fix the inverter and battery (if a battery is incorporated
in the BLINDS system);
perform electric wiring according to the current standards.
CAUTION! Perform installation taking into account material properties of walls of the
building, where the BLINDS are to be mounted, as well as the window design and
materials, if the product is to be mounted into the window aperture. Therefore, use
proper tools and fixings (rods, anchors, screws, etc.) that are resistant to corrosion and
climatic impact to ensure secure attachment of the product under operation conditions.
7.2. Install the cornice with casing
containing electric motor,
mechanisms and control unit as
follows:
7.2.1. Mark out points for holes to fix latch
brackets on the prepared working
surface making sure to locate them at
equal intervals and ensuring
horizontal position of the casing and
cornice.
Casing containing electric motor,
mechanisms and control unit
located under cornice
Fixing screw
Hooking bracket for installation of
cornice and casing
Slotted side guides
Mushroom corbel for installation
of side guiding groove
Slats with solar cells
ламелі з сонячними елементами
Slats with solar cells
7.2.2.
Make holes to fix the latch brackets depending -on the installation place, i. e.:
for concrete, stone or solid brick walls — Ø 8 mm holes using a
rotary hammer , e. g. REDIBOLT-N 8x120/M6/75 anchor and a
yellow zinc plated nut or equivalent;
for aerated concrete walls — Ø 6 mm holes using a
drill for a
sleeve anchor used together with a screw, e. g. TGS 8x60/5.0-
6.0 anchor (yellow zinc plated) and DIN571 6.0x100 screw or an
equivalent set of fixing elements of a proper material;
for wooden walls — Ø 4 mm holes using a
drill for a stainless
steel screw, e. g. DIN571 6.0x100 screw for Group 6 A2 wood or
equivalent;
for metal window frames — use a self-tapping screw
without
drilling a hole ;
e. g. for frames made of stainless steel, use TEX-Him 6.3x38C1
screw as per ISO 15480 or equivalent.
7.2.3.
Fix the latch brackets to the working
surface using an appropriate fixing method