Items Not Included
How to install your
#65101-11752-D
Motorised Honeycomb Blind
Included Hardware
measuring
tape
drill with
2mm bit
phillips bit or
screwdriver
pencil
knife
The hardware can be found in
the end of every box.
1
Installation Brackets
15mm Screw
31mm Screw
50mm Screw
63mm Screw
Installing inside the window frame…
At top of window frame, measure 40mm in from each end and mark
with a pencil (30mm for blind width less than 610mm); this is the
centre of the outer brackets.
Place brackets in position 2mm back from the front of the window
opening and mark where the screws will go.
We recommend drilling pilot holes for the screws using a 2mm bit.
Fix the brackets into position using 2 long screws for each bracket into
the first two holes closest to the front of the bracket.
If more brackets are supplied, space them evenly between the first
two brackets.
Installing outside the window frame…
Measure 40mm (30mm for blind width less than 610mm) in from top left
and top right of where the blind will sit (normally edge of architrave)
and mark where the screws will go; this is the centre of the outer brackets.
We recommend using a spirit level to align brackets if not installing on
the architrave.
We recommend drilling pilot holes for the screws using a 2mm bit.
Fix the brackets into position using two 31mm installation screws for
each bracket.
If more brackets are supplied, space them evenly between the first two
brackets.
Note: If spacer blocks are required then always make sure the raised
side of the spacer block is against the bracket, then use 50mm screws
when using 1 or 2 blocks, or use the 63mm screws if using 4 blocks.
2
Install Battery Tube
Please first take off the battery clip from the battery tube.
Attach to back of headrail:
Screw the battery clips into the pre-drilled
holes on the back of the headrail using one 15mm screw for each clip.
Or attach to window frame:
Position the battery clips 113mm apart and
within reach of the motor cord using one 15mm screw for each clip.
Unscrew the end cap of the battery tube and load 8 AA Batteries (Not
Included).
Clip the battery tube to the battery clips.
Connect the battery tube to the motor of the blind.
Installation
Bracket
Battery Clip
(Attached to
Battery Tube)
Wall Plugs for
Brick or Cement
using a 6mm bit
(If requested)
8 x AA Batteries
Required Tools
Spacer Block
(Outside Mount Only)
113mm
40mm
Space Evenly
Space Evenly
40mm
3
Install Blind
Position the top front lip of the blind under the top front lip of
the brackets.
Push the blind up at the back to click into position as per
diagram to the right.
!
1
