Please write a review on our
website at…
www.venetablinds.com.au
Feedback?
We would love to know how you
went with your installation…
100% Child Safe
This product has no cord or
chain and is 100% Child Safe
How to install, operate and maintain your
Motorised Honeycomb Blind
Operating your
Blind
Use the remote to raise and lower the blind. Ensure the channel displayed on the remote
matches the channel of the motor.
Replacing Batteries
Disconnect the battery tube from the motor, then remove the battery tube from
the battery clips and remove the end cap.
Replace the AA batteries, re-clip the tube into place and re-connect the motor.
2
Manual Control of Blind
You can operate the blind using the manual control button found on the
front of the blind head rail.
Do not continue to press the manual control
button over 4 seconds.
3
Dusting
Dust can be removed using a feather duster or vacuum with brush attachment on low suction.
4
Spot Cleaning
Use a warm damp cloth or a mild detergent for tougher stains.
Dab the affected area, but do not rub the fabric. Finish with just a warm damp cloth.
Allow the fabric to dry in the lowered position.
5
Ultrasonic
If ultrasonically cleaning the blind please specify that a mild solution must be used.
Note the rails should never be immersed in liquid.
4
Remote Control
Install battery into the remote.
Optional: Install your remote control holder using two 15mm screws. Each
screw should be placed with a distance of 82mm between them, and
should protrude 3.5mm from the wall. Attach the remote holder to the wall.
Note: The remote is pre-programmed in the factory and will work straight
out of the box. If you would like to change the settings, please see the
appendix on the next page.
Need HELP?
Call our
Customer Service team
for assistance
1300 836 382
82.5mm
3.5mm
Maintaining your
Blind
1
Installation
Continued…
Great Job… Enjoy your new Veneta Blinds!
The Light Guard is to be placed at the front and the back of the blind at
either side as per image.
Note: all 4 Light Guards are identical.
Note: try to leave a 2mm gap between the blind (bottom rail) and the
Light Guard to prevent scraping.
Note: use the double sided tape on the short side of the Light Guard to
attach to the window frame.
Place the front Light Guards in position and mark the edges with a pencil.
Remove the double sided tape and carefully place the Light Guard in position.
Place the rear Light Guards in position and mark the edges with a pencil.
Remove the double sided tape and carefully place the Light Guard in position.
5
Install Light Guard (optional)
2
