|
53
June 2020
|
Solar Stik
®
, Inc.
SYSTEM SETUP AND OPERATION GUDIE FOR THE 1 kW HYBRID POWER SYSTEM (HPS)
PRELIMINARY DRAFT
Saving/Uploading Programmed Parameters
Saving Programmed PRO-Verter Parameters to SD Card
All the programmed parameters can be saved on an SD card (FAT 16/FAT 32 format, up to 16 GB
capacity). The parameters will be saved in File named “xxxx_yyy.cfg”, where the first group of 4
digits xxxx is the model number of the inverter charger and the second group of 3 digits yyy is the
Revision #. for that model, e.g., 074.
• For saving, first insert the SD card into the SD card slot.
• Then, go to “Parameter Save” screen . Steps are given below:
Select Group
Charge Curve
*
Select Parameter
OTHER FUNCTION
*
Select Parameter
OTHER FUNCTION
POWER SAVING
0=Disable
ENTER key
DOWN key x 4
ENTER key
DOWN key x 10
Password key in
0000
Select Parameter
OTHER FUNCTION
PARAMETER SAVE
0=No
*
Saved file end.
ENTER key
Select Parameter
OTHER FUNCTION
PARAMETER SAVE
1=Yes
Select Parameter
OTHER FUNCTION
PARAMETER SAVE
0=No
*
ENTER key
DOWN key
Press ENTER key, hold for 3
to 4 seconds and release
Select Parameter
OTHER FUNCTION
PARAMETER SAVE
0=No
*
*
ENTER Key
Uploading Saved PRO-Verter Parameters from SD Card
If there is an “xxxx_yyy.cfg” file in the SD card with stored programmed parameters, then upon
inserting the card, the remote control will ask to upload the Config file. Press the ENTER key to
confirm or the BACK key to cancel.
• Asks to confirm or cancel uploading of saved parameters.
• Choose Yes by pressing ENTER key.
Configuration uploading.
Upload Conf?
Yes=Enter key
No=Back key
Upload Conf
1%..