Sola ARGO, Руководство по эксплуатации

Страница: 63 / 84

- 63 -
Fig. 8.14 Fig. 8.14
4- Mount the necessary number of sections for the desired
dose. To change the section configuration, remove the
circlip, mount the desired sections and re-install the
circlip (Fig. 8.15).
TO DETERMINE THE NUMBER OF SECTIONS
TO BE MOUNTED, SEE SECTION 8.1.2
PRELIMINARY FLOW TEST.
4 4 SECTIONS SECTIONS 11 SECTION SECTION
Fig. 8.15 Fig. 8.15
5- Re-install the roller and side support and secure it with
the two knobs.
MAKE SURE THAT THE CIRCLIPS ARE PROPERLY
MOUNTED IN THEIR HOUSING. TO DO THIS,
TURN THE CIRCLIP. DO NOT FORGET THE
R-CLIP;
THE DISPENSER WILL NOT WORK
WITHOUT IT (Fig. 8.16).
Fig. 8.16 Fig. 8.16
8.1.2 PRELIMINARY FLOW TEST
You must a complete a number of steps before performing
the test:
PERFORM THE PRELIMINARY FLOW TEST ON
ALL DISPENSERS.
1-
Close the valves above the dispensers (Fig. 8.17).
Fig. 8.17 Fig. 8.17
2-
Fill the hopper with product (see section 5.5.2 CENTRAL
HOPPERS).
3-
Remove the roller to see the type and quantity of sectors
installed (see section 8.1.1 ADJUSTING THE DISPENSER).
4- Place the sack that is supplied or a container below the
dispensers and open the rubber cover by releasing
the latches; there is one on either side of the dispenser
(Fig. 8.18)
Fig. 8.18 Fig. 8.18