Sokkia GSR2700 ISX, Руководство по эксплуатации

Страница: 55 / 106

GSR2700 ISX Operations Manual 45
System Setup
Chapter 5
3. If you are using an external radio device:
• Mount the radio bracket near the top of the tripod leg, as
shown in Figure 13, Typical RTK Base Setup (external radio) ,
page 43.
• Attach the radio to the bracket.
• Set up the tripod for the radio antenna and then mount
the radio antenna on the tripod, ensuring it stands
vertically and is at least 1 metre from the receiver.
• Connect the radio antenna to the radio.
• Connect power to the radio device.
• Use a radio communications cable to connect the radio to
the receiver’s COM2 (white) port (see Section 2.2, Ports ,
page 11).
NOTE For additional details about connecting Satel radios to the
receiver, see Appendix C, Configuring Satel Radios , page 70.
4. Press the power button to turn on the receiver. It will
initialize and issue a “Receiver Ready” message (or matching
sound) when it completes its initialization (see Table 20,
Audible Annunciator Conditions , page 34.
5. To verify that your RTK base position is fixed, ensure that the
LED indicator on the satellite tracking gauge is flashing (see
Table 10,
Satellite Tracking Gauge Indicators , page 25).
6. To verify that corrections are being transmitted:
• Check the internal radio status LED indicator: the LED
will flash green (see Table 19, Internal Radio Status LEDs ,
page 33).
- or -
CAUTION
To avoid damaging the receiver, make sure
both the receiver and the radio are
off
before you connect the devices.