Sokkia GSR2700 ISX, Руководство по эксплуатации

Страница: 64 / 106

54 GSR2700 ISX Operations Manual
Chapter 7
Collecting Data
NOTE The SDR+ software can only store RTK data on the data
collector. Raw data is always stored in the receiver’s internal
memory.
When you connect the data controller to the receiver (using either
a wireless connection or a cable), you establish a communication
link between the two devices and the controller will control the
behavior of the receiver.
When you turn on the GSR2700 ISX, the receiver will use its
preset POWERUP configuration until the controller takes control.
Commands sent to the receiver through the data collector will
supersede the POWERUP configuration on the receiver. The
receiver will use the POWERUP configuration again when you
turn the receiver off and then back on again.
NOTE For details about establishing a Bluetooth connection between
the receiver and an Allegro CX, see Appendix B, Allegro CX
Bluetooth Connections , page 66. For details about collecting
data with software on the handheld, refer to the software
documentation (e.g., the SDR+ User’s Guide ).
7.2.2 Receiver logging to internal memory with
POWERUP
When you use the GSR2700 ISX without a handheld data
controller, the receiver will typically use the preset POWERUP
configuration that is loaded on the receiver.
7.2.2.1 Defining receiver behavior with POWERUP
You can define what type of information should be collected or
transmitted as RTK corrections by using
POWERUP Configuration
Manager software, which lets you customize and transfer a
POWERUP configuration to the GSR2700 ISX.
NOTE You can also work with POWERUP configurations in SOKKIA’s
Planning software. The GSR2700 ISX does not support the use
of schedules.