novaPDF v7
60
novaPDF v7 User Manual
Copyright © 2011 Softland
You can select a simple adjustment (only by the margins) or a more complex one which involves
zooming, aligning and changing the origin of the document content.
Fit whole page to margins
If the "Fit whole page to margins" radio button is selected, the output page will be automatically
zoomed so it will fit in the printing region. You can see the automatically calculated zoom percent
in the Zoom field. Also the left and top origin are automatically calculated according to the left
and top margins.
Customize zoom and origin
The above behavior (when "Fit whole page to margins" is set) is probably sufficient in most of the
cases. But if you want to have a more accurate control of the result, you can select the
"Customize zoom and origin" radio button and manually enter zoom and page origin.
Zoom and origin
You can set here the zoom, alignment and origin of the document content in the PDF. The
controls from this group are active when "Customize zoom and origin" is set.
Zoom
When "Customize zoom and origin" is set you can set the zoom factor of the document from 1%
to 400% by entering a value or pressing the Up and Down arrows. When "Fit whole page to
margins" is set the zoom factor is calculated automatically.
Center horizontally
If you set this option the contents of the document will be centered horizontally. At the same time
the Align to right option will be disabled and the Left origin is calculated automatically.
Center vertically
If you set this option the contents of the document will be centered vertically. At the same time
the Align to bottom option will be disabled and the Top origin is calculated automatically.
Align to right
If you set this option the contents of the document will be aligned to the right margin. At the
same time the Center horizontally option will be disabled and the Left origin is calculated
automatically.
Align to bottom
If you set this option the contents of the document will be aligned to the bottom margin. At the
same time the Center vertically option will be disabled and the Top origin is calculated
automatically.
Left origin
The left origin of the document contents. It can be modified by entering a value or pressing the
Up and Down arrows if the Center horizontally and Align to right options are not set.
Top origin
The top origin of the document contents. It can be modified by entering a value or pressing the
Up and Down arrows if the Center vertically and Align to bottom options are not set.
Units
You can change the measurement units from the Units drop down list. The available values are
millimeters, inches and points. Changing the units will recalculate the margins and the origins.
Preview
You can preview changes you do on the Margins and Zoom window without actually saving them.
