HYD 3K~6K-EP
User manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd
- 15 -
3.6. Moving the HYD 3K~6K-EP
Step 1
Open the packaging, insert hands into the slots on both sides of the inverter
and hold the handles, as shown in Fig.3-4.
Fig. 3-4 Moving the inverter
①
②
Step 2
Lift the inverter from the packing case and move it to the installation
position.
To prevent device damage and personal injury, keep balance when
moving the inverter because the inverter is heavy.
Do not put the inverter with its wiring terminals contacting the floor
because the power ports and signal ports are not designed to support the
weight of the inverter. Place the inverter horizontally.
When placing the inverter on the floor, put foam or paper under the
inverter to protect its shell.
Attention
3.7. Installing HYD 3K~6K-EP
Step 1
Determine the positions for drilling holes, ensure the hole positions are level,
then mark the hole positions using a marker pen, use the hammer drill to drill holes
on the wall (Aperture
Φ
10 mm). When drilling, keep the impact drill perpendicular
to the wall and drill slightly deeper than the length of the expansion pipe. After
drilling, please check whether the hole position is suitable with the back plate. If
the error is too large, please reposition the hole.
Step 2
Slowly hammer the expansion screw into the drilled hole.
Step 3
Position the back plate well, place the shrapnel and flat pad, and fix the back
plate with hexagon nut.
Step 4
Hang the inverter on the back plate and lock the inverter and the back plate
with M6 hex screw.
Step 5
You can secure the inverter to the rear panel and protect if from stealing by
installing an anti-theft lock (this action is optional).
