Xxx xxxxxxxxx xx xxxxxxx xxxxxxx
Xxxx xxxxxxxxxxx xxxxx xxxxxxx
X.X
Xxxxx xxx xxxx xxxx xxxx xxxxx xxxxx xxx
xxxx xxx xxx xxx xxxxxxx xxxx xxxx.
Xxxxx xxx xxxxx xxxx xxxx xxxxx xxxxx xxx
xxxxx xxxx xxx xxx xxx xxxxxxx xxxxx xxxxx.
X
XX
objects.
Before making any adjustments
The operation of turning control
(for caterpillar drive machine 9.0
and 11.0HP)
4)
: Oil change every 25 hours of heavy work
Assemble the machine as illustrated
at the end of these operating
instructions.
It is essential to check the oil level
Refill or top up with engine oil (see
“engine instructions”) as required.
For transportation reasons, the
tires may show a higher tire
pressure. Check the tire pressure
and ajust accordingly (approx. 1
bar).
Adjust coupling for the worm drive
and drive system (see
“maintenance”).
(5.5HP, 6.5HP, 9.0HP and 11HP)
Adjust drive lever (see
“maintenance”).
Turn off the engine
Remove the ignition key and the
spark-plug connector.
Wait until the engine has cooled
down.
Press the left turn grip which is under the left
hand bar and the machine turns left.
Press the right turn grip which is under the
right hand bar and the machine turns right.
Before using the machine
for the first time (5.5HP,
6.5HP, 9.0HP and 11HP)
Adjust the machine to conform
to the snow conditions:
Setting a drive wheel to
freewheel (Machines with
wheel drive without
free-wheeling lever)
Risk of injury
Figure 4
Adjust working position (machines
with caterpillar drive)
For 9.0/11HP caterpillar drive
Position I: For heavy snow which has
iced over, worm is pressed into the
ground
Position II: For normal snow
conditions
Position III: For clearing uneven
paths or transporting the machine.
Worm is at a greater distance to the
ground.
Engine does not work
Fuel tank empty
Fuel has gone stale
Fill fuel tank
Drain out fuel into a
suitable container in the
open air. Fill up tank with
clean fresh fuel
Set the choke lever to
“CLOSE”
Set throttle lever to
“SLOW”
Put spark-plug connector
on the spark plug
Clean air filter
1)
Clean spark plug
1)
. Have
defective one replaced
2)
Set choke lever to “OFF”
and start engine
Engine is cold. Choke Lever is not
set to “CLOSE”
Throttle lever is not set to “SLOW”
Spark-plug connector not
connected
Air filter dirty
Spark-plug dirty or defective
Carburetor flooded
Figure 8
Do not operate the
machine without wearing
adequate winter garments. Wear
footwear which will improve footing on
slippery surface.
The operation of any powered
machine can result in foreign objects
thrown into eyes, always wear safety
glasses or eye shields during
operating or while performing an
adjustement or repair.
Before using the snow blower
equipment, please thoroughly inspect
the area and remove all doormats,
sleds, boards, wires and other foreign
Troubleshooting
Risk of injury from starting the machine by accident
turn off the engine
Remove the ignition key and the spark-plug connector.
Wait until the engine has cooled down.
Caution
Faults encountered when operating the machine sometimes have simple causes which you
can remedy yourself. If you are in any doubt, or if you expressly instructed to do so, seek
the help of our service department.
Have repair work carried out only our service department which will use original
replacement parts.
Before doing any work on this machine
Action to take
Fault
Possible cause
20
3
