X
XX
Step 5: 5-1) Assemble knighthead to the
rocker:
Step 2: Connect handle bar and shift
board by screws.
1) Push the fuel lock (under air clear)
to “ON”
2) Push the choke lever to “CLOSE”
(cold engine).
3) Move the throttle lever away from
SLOW position, about 1/3 of the way
toward the FAST position.
4) Turn the engine switch to “ON”
Check contents of fuel and oil level,
as required fill up with fuel and oil
(see “Engine instruction”)
Danger
If you start the engine in
an enclosed space, move
Start the engine
Figure 2
For machine with lever (Figure 1,
Item 5): press lever forward to set
the flap (2) higher and back for
lower.
For machine with lever: loosen
knob (1) and set flap (2) higher or
lower as required.
The steeper the angle of the flap (2) is
set, the higher and the further the
snow will be ejected.
Set the throw distance
Set the direction of throw
Risk of injury
Do not set the flap (2) of
the throw-out chute (3) in
the direction of people, animals,
windows, cars and doors.
Put the throw-out chute (3) in the
desired direction by rotating the
rocker (figure 1, item 7)
the machine immediately afterwards
into the open air. Never leave the
engine running in an enclosed space.
Before starting the engine, release
coupling levers (Figure 1, item 1 and
2)/coupling bar (Figure 1 item 1)
Start with pull starter
assembled as the picture shows. The other
two sets of arc-shaped clip plate sets
assemble same as previous.
4-3) Tighten the screw as the
picture shown.
4-2) Please make sure the pieces are
Step 4: 4-1) Put the throw-out chute to
the set and assemble arc-shaped clip
plate.
Step 3: Take off the wheels. Install
handle bar to the frame, fix it by screws
and put on the wheels.
7
16
