xxxxX
xxxxX
X
XX
ground.
The details assemble step, please
reference to 6.5HP type.
Step 8: 8-1) Assemble knighthead to
the clean staff
8-2) Fix the knighthead to
right handle bar.
Figure 1
Fill up with fuel only in the
open air and when the engine has
been switched off and is cold. Do not
smoke whilst filling up.
Never fill up with fuel to top. If fuel
overflows, let the overflowed fuel
evaporate completely before you start
engine.
Store fuel only in suitable containers
designed to take fuel
Check oil level, top up as required
(see “engine instructions”).
Fill up with fuel (for types of fuel
see specifications in the engine
instruction), close the fuel tank
cap and wipe away remains of fuel
Risk of injury
Keep other people, in
particular children and
domestic animals away from the
danger area.
Operating the machine only when it is
in the faultless and safe-to operate
condition.
Inspect the ground over which the ma
-
chine is to operate and remove all
objects which could be picked up by
the machine and hurled out.
Working only when there is sufficient
illumination. Always be sure of your
footing, and keep a firm hold on the
handle, walk, never run.
If the machine should start to vibrate
abnormally, stop the engine and check
Danger of explosion
and risk of being burnt.
immediately for the cause. Vibration is
generally a warning of trouble.
Work slowly and carefully, especially on
uneven or non-hard-surfaced paths, or
when you are moving backwards.
Never operate the machine without
proper safety guards.
Do not overload the machine capacity by
attempting to clear snow at too fast a
rate.
Set the distance between worm housing
and ground in such a way that no
extraneous material (e.g. stones) is
taken up by the machine.
If the machine strikes extraneous
material (e.g. stones) or exhibits
unusual vibrations, switch off the
machine and inspect it for damage. Get
any damage you discover repaired
before you work the machine again.
Befor you put the machine to work, let
the engine run to warm up.
When you have finished work, leave the
engine running for a few mintues to
eliminate the moisture.
Adjust throw-out chute (see “Set the
direction and distance of throw”)
Starting the engine (see “starting the
engine”)
With the coupling lever (1 and 2)
released, choose a forward gear with
shift level (6)
Press the coupling lever for worm
drive (1) and hold it down; worm and
throw turbine are driven.
Press the coupling lever for drive
system (2) and hold it down; the
machine moves forward and clears the
snow.
Caution
Risk of damage to the
machine
Fill up with fuel and check the
oil level
Working with the snow
clearing machine
(For 5.5HP, 6.5HP, 9.0HP and 11HP)
3) For 9.0/11.0 HP
caterpillar track
18
5
