Xxx X.XXX.XXX.
X
XX
2
Safety feature
For 5.5/6.5/9.0HP
Coupling bar (For 4.0 HP)
Coupling lever for the worm
drive (1)
Coupling lever for the drive
system (2)
Symbols on the machine
At various places of the machine you will
find a safety and warning notice
represented by symbols or pictograms.
These symbols have the following precise
meanings:
Figure 1
Fault
Lever is not set to “CLOSE”
Spark-plug connector loosely
connected
Stale fuel water or dirt in the fuel
system
Drain off stale fuel into a
suitable container in the
open air
1)
.
Fuel up tank
with clean, fresh fuel
Clean fuel filter cap and
vent hole
Clear air filter
1)
Have carburetor rest
2)
Put in a new shear bolt
(see “replacing a shear
bolt”)
Stop engine and eliminate
blockage.
Adjust coupling cable (see
“Adjust coupling for the
worm drive”
2)
Tighten slack V-belt (See
“Tightening the V-belt”).
Have torn V-belt replaced
Adjust coupling cable (see
“Adjust coupling for the
drive system”)
Tighten slack V-belt (See
“Tightening the V-belt”)
2)
.
Have torn V-belt replaced
2)
Remove ice accumulation
(See “Tightening the
V-belt”)
Stop the engine. Tighten
loose bolts and nuts. Have
damaged worm repaired
2)
.
Have friction-wheel rubber
replaced
2)
Set choke lever to “CLOSE”
Vent hole in fuel filler cap blocked
Air filter dirt
Carburetor altered
Shear bolts broken off.
Worn or throw-out chute blocked
Coupling cable for worm drive not
correctly adjusted
V-belt slack or torn (4.0 HP)
Machine does not work
Excessive vibration
Machine does not drive
forward
V-belt slack or torn (4.0 HP)
Drive system iced up (4.0 HP)
Friction-wheel runner torn
Loose parts or damaged worm
Coupling cable for drive system
not adjusted correctly
Connect spark-plug
firmly
Engine rubs unevenly
Possible cause
Action to take
Risk of injury or damage
to property
Read these operating
instructions through
carefully before
operating the machine
in particular the chapter
entitled “For your safety”
Risk of being burnt.
Keep at a safe distance
from hot parts of the
machine.
Only touch parts of the
machine when they have
come to a complete halt.
The worm driver switches off if the
user releases their hold on this
coupling lever.
The drive system switches off if the
user releaes their hold on this
coupling lever.
Safety devices are provided for your
protection and must always function
properly. You may not remove,
change or circumvent them.
Risk of injury from
rotating parts. Keep hands
and feet away from
rotating parts.
Check the contents as you unpack the
machine.
When user releases hold of this bar, the
worm driver switches off and the
machine comes to a halt.
For 4.0 HP
Risk of injury from
throw-out snow or solid
objects.
Unpacking and assembly
21
