Xxx X.XXX.XXX.
X
XX
Warranty
For 4.0 HP
Assemble instruction.
non-use
Preparing the machine for
Replacing the clearing plate
(For 5.5HP, 6.5HP, 9.0HP and
11HP)
Stop the engine
The warranty term issued by SNOWPRO
valid in the USA and Canada.
We remedy faults to your machine free of
charge within the scope of the warranty
provided that the cause proves to be a
material or manufacturing defect. Should
you need to call upon the warranty,
please apply to the vendor of your
machine or the the nearest agency.
Please see warranty included.
open air (see “engine instructions”).
When the machine is not to be used for
more than a month, e.g. after the winter:
Prepare the engine (see “adjusting
the skids”).
Clean machine.
To protect from rust, wipe over all
mantel parts with an oily cloth or
spray with spray lubricant.
Park the machine in a clean, dry
enclosed space.
Remove screw (6), washers (7) and
nuts (8)
Replace clearing plate (5)
Screw new clearing plate to housing
with screw, washer and nuts.
Tip machine backwards.
Remove screw (4) and nuts (5).
Replace clearing plate (2).
Screw new clearing plate to housing
with screw and nuts.
Tip machinery back again; check
setting (see “adjusting the skids”).
Replacing the clearing plate (For 4.0HP)
Figure A
Step 1: Please check the full components
against above picture shown, and make
Danger of causing an
explosion by fume igniting.
Before you prepare the
machine for non-use, empty the fuel
tank into a suitable container in the
To avoid damage to the machine or
starting problems arising from
moisture, let the engine run for a
few minutes before switch off (to
dry out).
Set the throttle lever to “OFF”
up to a maximum lenth of 50cm:
- H07RN-F3X1.5mm
2
up to -26
0
C
- H07BQ-F3X1.5mm
2
up to -40
0
C
Caution
If the electric starter is not
connected properly,
damage could occur to the machine or
in its vicinity.
Make sure that the main supply
network
-- is operating in conformity with the
specifications on the starter
identification plate at 220-230V
and 50 Hz (110/60Hz).
-- is protected by an appropriate fuse
system.
1) Push the fuel lock (under air
clear) to “ON”
2) Push the choke lever to
“CLOSE” (cold engine).
3) Connect extension cable first
with the plug and then with a
mains socket.
4) Press start button long enough
(Max. 5 sec.) for the engine to
start. For a cold start, wait at least
10sec. before attemepting to start
the engine again.
5) Preheat the engine and push
back the choke lever to “OPEN”.
6) Separate the extenstion cable
first from the mains and then from
the electric starter.
Push the engine switch to “OFF”
Push the fuel lock (under air clear) to
“OFF”
Put in gear (For 5.5HP, 6.5HP, 9.0HP and
11HP)
Figure 1
Figure 7
9
14
For 5.5/6.5/9.0HP
