SnowEx Drop Pro 600, Руководство пользователя

Страница: 17 / 24

Lit. No. 78565, Rev. 02 17 November 1, 2019
OPERATING THE SPREADER – CAB CONTROL
CAB CONTROL CODES
continued
Error Codes – Spreader Operation Stopped –
continued
Code Definition Possible Cause Suggested Solution
CP Not applicable to tailgate
spreaders. See suggested
solution.
Not applicable to tailgate
spreaders.
Reset the control by pressing the ON/OFF
button. If CP code continues to display, contact
authorized dealer.
Ct Control is hot. Cab temperature is too high.
Control overheated.
Turn spreader OFF and allow control to cool off.
EF Excessive drive faults. Too many HO and/or SO
error codes; hopper module
overheating.
Control times out for 60 seconds.
Ensure that auger and/or spinner are not jammed.
Lb
Low battery. Hopper
module is sensing <6V.
Bad connection or low battery.
Snowplow or other vehicle
power use may be driving
down voltage.
Voltage is measured at the hopper module, so
Lb
code may indicate cable voltage loss. Check
battery, alternator, and connections.
nC No connection. Spreader not connected to
vehicle harness.
Connect vehicle and spreader harness.
Check vehicle harness fuse.
Inspect spreader and vehicle harnesses.
Check module.
OH Overheating. Spreader module is too hot.
Spreader module malfunction.
Accessories wiring/function
problem.
Drive motor overload.
Allow a cool-off period – 60 seconds or longer.
Check for loose harness connections.
Check accessory connections. Check integrity of
accessory wiring and harness.
Clear jammed material.
Contact authorized dealer.
OH . Overheating module –
microprocessor.
rS Reset of spreader module. Power loss to module detected
on startup.
Reset the control by pressing the ON/OFF button.
Check vehicle harness and battery connection.
SO Auger drive overload –
software trip.
Material jammed in auger area. Inspect auger and auger drive components for
alignment and condition. Check for damage to
bearings, shafts, and sprockets.
Adjust and replace parts as required.
SO . Auger drive overload –
hardware trip.
SP Auger power issue.
No motor present.
Auger drive motor is not
connected.
Possible motor defect.
Check connections to the motor (SPIN and GND
posts on the module).
Replace the motor.