®
EEWH316A Tire Changer Operation Manual
Page 18
Operation Manual
MAINTENANCE NOTE:
IF THE MOUNT/DEMOUNT HEAD NYLON INSERTS
ARE WEARING OUT PREMATURELY, THE CAUSE
IS THE OPERATOR’S FAILURE TO CORRECTLY
SET THE RIM DIAMETER ADJUSTMENT KNOB,
CAUSING THE INSERT TO INCORRECTLY
CONTACT THE RIM.
NOTE:
ONCE THE MOUNT/DEMOUNT HEAD IS
POSITIONED PROPERLY, IDENTICAL WHEELS
MAY BE CHANGED WITHOUT HAVING TO RESET
THE HEAD.
F.
Insert the mount/demount tool between the bead
and the mount/demount head. Pry the bead onto the
mount/demount head using the mount/demount head
as the leverage point. To make this operation easier,
insure that the bead of the tire, 180º across from the
mount/demount head, is in the drop center of the
wheel. Push the tire into the drop center with your hand
or bead depressor tool if necessary.
It is suggested that the mount/demount tool be
removed after lifting the bead onto the mount/demount
head (Fig. 4.1-5), however, you may remove the tool
after the bead has been removed.
333
Fig. 4.1-5
G.
Rotate the turntable clockwise (pedal down) and, at
the same time, push down on the tire sidewall to move
the bead into the drop center of the rim (Fig. 4.1-6).
334
Fig. 4.1-6
H.
Repeat the process for removing the lower bead.
This time, lift the bead opposite to the mount/demount
head to keep it in the drop center (Fig. 4.1-7).
Pivot the swing arm to the right and remove the tire.
335
Fig. 4.1-7
4.2 MOUNTING TUBELESS TIRES
A.
Clean entire rim surface (Fig. 4.2-1).
336
Fig. 4.2-1
Содержание EEWH316A
Страница 24: ... EEWH316A Tire Changer Operation Manual Page 24 Operation Manual BLANK PAGE ...
Страница 25: ...Instruction opérationnel EEWH316A Air Electrique Demont Pneus P N ZEEWH316A ...
Страница 26: ... PAGE VIERGE ...
Страница 28: ... PAGE VIERGE ...