Snap-On EEWH316A, Руководство по эксплуатации

Страница: 14 / 48

®
EEWH316A Tire Changer Operation Manual
Page 14
Operation Manual
2.0 INSTALLATION
Your new Snap-on EEWH316A Tire Changer requires a
simple installation procedure requiring only a few
moments.
Follow these instructions carefully to insure proper and
safe operation.
The Tire Changer is delivered mounted to a wooden skid.
Remove tire changer from its mounts carefully, taking
care to avoid any back strain.
Place Changer where proper operation will be
unobstructed to all sides. Install the machine in a covered
and dry place.
Once placed in the desired location the tire changer must
be bolted to the floor using only the rear two mounting
holes. Mounting anchors are provided with machines.
Tire Changer must be anchored to concrete floor.
2.1 ELECTRICAL INSTALLATION
BUILDING ELECTRICAL INSTALLATION MUST BE
MADE BY A LICENSED ELECTRICIAN.
Check that the electrical specifications of the power
source are the same as the machine. The machine uses
110v, 60 hz, grounded single phase 20 amp source.
Electric specifications are clearly marked on a label at
the rear of the machine.
FAILURE TO PROVIDE PROPER ELECTRICAL
SUPPLY AND GROUNDING WILL CREATE A SHOCK
HAZARD TO THE OPERATOR.
540
2.2 BEAD BREAKER INSTALLATION
The side mounted Bead Breaker is shipped from the
factory dismounted for a more compact shipping
package.
A.
Cut the plastic tie strap, which secures the Breaker
Arm to the cabinet pivot.
B.
Remove the “C” clip from the top of the pivot pin,
slip the pin out of the hole.
C.
Place the Breaker Arm into position and insert the
pivot pin through the top and bottom holes.
D.
Replace the “C” clip retainer onto the pivot pin.
E.
Locate the spring located at the rear of the pivot
mount. Place the free end of the spring onto the “ear”
located on the Breaker Arm just forward of the pivot.
HINT:
You may tie a small rope or cord onto the free
end of the spring then run the cord through the hole.
Pull the spring end toward the ear and loop free end
over the ear tab.
2.3 AIR INSTALLATION
THE AIR INSTALLATION MUST BE MADE ONLY BY
QUALIFIED PERSONNEL.
EXCESSIVE AIR PRESSURE CAN SERIOUSLY
INJURE PERSONNEL AND DAMAGE THE
MACHINE.
Ensure that the line pressure is within the limits required
by the machine. If the pressure exceeds 170 psi (12
bar) it is mandatory to install a pressure regulator
before the air inlet of the machine.
If the air pressure is lower than the minimum required
of 110 psi (8 bar) the clamping power of the turntable
and the bead breaker power may be insufficient for
certain tires and substantially reduces tire changer
performance.
It is suggested that the shop air supply be equipped
with a water separator/dryer type modification for
maximum performance.