EN - 19
E.
Lubricate piston rods of turntable air cylinders with
oil as needed.
F.
Periodically wash all plastic parts with cold water
and soap or window cleaner.
G.
Check the bead breaker pads. Replace if worn.
H.
Discharge
water from air fi lter every day.!! (Do this
by pressing the knob “
B
” upward. Water will automati-
cally be discharged.) (see ‘
B
’ at Fig.29).
I.
Check the automatic air lubricator oil level weekly.
When adding oil to the lubricator, disconnect the air
supply fi rst, discharge all pressure by pressing ‘
B
’ and
remove the fi ll screw ‘
A
’, than add oil as needed. Make
sure seals are in place when place again the cap ‘
A
’.
Fig.29
NOTICE!
USE ONLY OILS FOR AIR DEVICES, DO NOT USE
BRAKE FLUID OR OTHER NON SUGGESTED LU-
BRICANTS.
Suggested oil for the fi lter/lubricator unit:
Snap-on air tool oil IM1PT
(for oils allowed see also label on machine)
1
2
6.0 MAINTENANCE
BEFORE STARTING ANY MAINTENANCE OPERA-
TION ENSURE THAT THE MACHINE IS DISCON-
NECTED FROM THE AIR AND ELECTRIC SUPPLY.
A.
Periodically clean the vertical hexagonal rod with
nonfl ammable liquid detergent.
After this immediately lubricate with a light lubricating
oil (Fig.27).
Fig.27
B.
Periodically clean all moving metal parts and lubri-
cate with oil.
C.
Weekly clean the teeth of the clamps (
1
) with a
wire brush, check the nylon clamping jaw insert and
(
2
) replace if worn (Fig.28).
Fig.28
D.
Inspect and replace as necessary the plastic mount/
demount head insert. The insert is held in place by a
small hex head set-screw. Remove the screw, replace
insert and re-install set screw.
