Snap-On EELR326A, Инструкция по установке и эксплуатации

Страница: 3 / 30

2
1 SAFETY AND OPERATING INSTRUCTIONS
1.
When using this lift, basic safety precautions should always be followed,
including the following.
2. Read all instructions in this manual and on the lift.
3. Inspect lift daily. Do not operate if it malfunctions or problems have been
encountered.
4. Never attempt to overload the lift. The manufacturer’s rated capacity is shown on
the identification label on the power side column. Do not override the operating
controls or the warranty will be void.
5. Before driving vehicle between the towers, position the arms to the drive-through
position to ensure unobstructed clearance. Do not hit or run over arms as this
could damage the lift and/or vehicle.
6. Only trained and authorized personnel should operate the lift. Do not allow
customers or bystanders to operate the lift or be in the lift area.
7. Position the lift support pads to contact the vehicle manufacturers recommended
lifting points. Raise the lift until the pads contact the vehicle. Check pads for
secure contact with the vehicle. Check all arm restraints and insure they are
properly engaged. Raise the lift to the desired working height.
8. Some pickup trucks may require an optional truck adapter to clear running boards
or other accessories.
NOTE: Always use all 4 arms to raise and support vehicle.
9. Caution! Never work under the lift unless the mechanical safety locks are
engaged.
10. Note that the removal or installation of some vehicle parts may cause a critical
load shift in the center of gravity and may cause the vehicle to become unstable.
Refer to the vehicle manufacturer’s service manual for recommended procedures.
11. Always keep the lift area free of obstruction and debris. Grease and oil spills
should always be cleaned up immediately.
12. Never raise vehicle with passengers inside.
13. Before lowering check area for any obstructions.
14. Before removing the vehicle from the lift area, position the arms to the drive-
through position to prevent damage to the lift and /or vehicle.