Snap-On EELR326A, Инструкция по установке и эксплуатации

Страница: 15 / 30

14
5.9 SAFETY RELEASE CABLE ROUTING AND ADJUSTMENT
The mechanical safety automatically engages. To release the mechanical safety, you
must first raise the lift approximately 2”, then pull the safety release lever down.
This disengages the power side safety dog and activates the safety cable to release
the slave side safety dog.
1.
Install the safety release bracket on each tower as shown in Figure 10. Attach the
safety pulley to the bracket using the 3/8” x 5/8” LG. shoulder bolt, 5/16”
lockwasher and 5/16” hex nut. Attach the pulley bracket, complete with pulley, to
the tower using the 5/16” x 3/4” LG. hex bolt, 5/16” flat washer, 5/16” lockwasher,
and 5/16” hex nut.
Figure 11 - Safety Release Pulley Installation
2. Refer
to Figure 12 for safety release cable routing. The end of the cable that has a
collar attaches to the slave side safety dog. The free end is fixed to the power side
safety dog using two (2) wire rope clips.
3.
Install the safety release handle onto the power side safety dog.
4.
Start routing the safety release cable from the slave side of crossmember. Feed
the cable over the small pulley, then guide the cable down along the inside of the
slave side tower. Pull the cable out through the opening in the back of the tower
near the safety dog.