SMC Networks ISE20CH-L, Руководство по эксплуатации

Страница: 25 / 108

-24-
No.PS
※※
-OMX0002
Outline of Settings [Measurement mode]
Power is supplied.
The product code is displayed for approximately 3 sec. after supplying power.
∗
: Within approximately 0.2 second after power-on, the switch starts.
[Measurement mode]
Detects the pressure after power is supplied, and indicates the display and switch
operating status. This is the basic mode; other modes should be selected for set-point
changes and other function settings.
Measurement mode screen
Sub display
In measurement mode, the display of the sub display can be temporarily changed by pressing the
or buttons.
∗
: One arbitrary display mode can be added to the sub display by setting the [F10] sub display setting.
If the sub display is switched during the arbitrary display setting, the display will be returned to the arbitrary display 30
seconds later. (The default setting does not include arbitrary display.)
Press the
button
once.
Press the
button
between 1
and 3 sec.
Press the
button
between 3
and 5 sec.
Set either of set
value or
hysteresis.
(3 step setting
mode)
(Refer to page 26 .)
Select the set
value, hysteresis
and delay time.
(Simple setting
mode)
(Refer to page 28 .)
Change the
function
settings.
(Function selection
mode)
(Refer to page 30 .)
Other Settings
•Zero-clear
function
•Key-lock
function
(Refer to page 60 .)
∗
: The outputs will continue to operate during setting.
∗
: If a button operation is not performed for 3 seconds during the setting, the display will flash.
(This is to prevent the setting from remaining incomplete if, for instance, an operator were to leave during setting.)
∗
: 3 step setting mode, simple setting mode and function selection mode settings are reflected each other.