SMC Networks IP8101 Series, Руководство по эксплуатации

Страница: 71 / 85

No.DIG-31900-OM002
70
Error Possible cause Countermeasure Reference
page
Low sensing
- Input current resolution is faulty. - Check the input current system.
5, 15
-Actuato
r’s sliding resistance is
large.
-Reduce the sliding resistance to as
little as possible.
-Operate only the actuator and check
the stick-slip movement. If this
movement cannot be recovered, it
’s
beyond the capacity of this
positioner.
-
-Dead band value is high. -Change the dead band with the
parameter mode.
44,45
-Operation takes time due to the
actuator’s large capacity.
-Wait until the actuator fills with air.
-
-Others. -Contact SMC representatives.
-
Hunting problem
-Actuator is uncalibrated. -Calibrate the actuator with the
parameter mode.
20 to 26
-PID constant after calibration is
improper due to use of a special
valve.
-Change the PID constant with the
parameter mode.
48 to 50
-There is play in the mounting of
the feed back shaft and actuator.
-Eliminate the play and properly
mount them.
10 to 12
-The input current itself is unstable. -Check the input current system.
-Ground properly.
15,16
67-
⑫
-Rotation resistance of the actuator
is significant due to ground and
piston packing.
-Reduce rotation resistance as much
as possible.
-
Large air consumption
-Air is leaking from the piping. -Check the piping, and stop
the leakage.
66-
⑧
-Air is leaking from the positioner.
(due to a seating failure of the pilot
valve. )
-Replace the pilot valve unit.
66-
⑦
-Others. -Contact SMC representatives.
-
Automatic calibration
is unavailable
- Fork lever fixing nuts are loose. -Tighten fixing nuts after fork lever
angle has been adjusted.
11,21,22
-The angle of the fork lever is in
excess of
–60/+60 degrees on
both ends of the actuator.
-Refer
to “2, fork lever angle
adjustment
” in “ ■
Initial Adjustment
”,
and securely adjust the angle to
+/-60degrees or less.
21,22
-The rotation angle of the actuator
is below 60 degrees or in excess
of 100 degrees.
-The standard positioner stroke is
from 60 to 100 degrees. Use it
within 60 to 100 degrees. 5