HAT828 High Speed ATS Controller User Manual Page 40 of 56
9
EVENT LOG
On the main screen press
key and select
Event Log
, and then press
key again, the
screen will show the event log interface.
Each event log includes:
Log date and time
Log type
Event
S1 power status
S2 power status
S1 3-phase voltage
S2 3-phase voltage
S1 frequency
S2 frequency
Maximum pieces of event log are 200. The first record is latest, and users could check every
records by up/down keys. The latest record will cover the oldest one when records amount exceeds
200.
Event log type includes: Action Event, Warn Event and Fault Event. Fault events are all fault
alarms while warn events are all warn alarms.
Table 19 – Action Events List
No.
Action Events
Description
1
Closing QS1
Record when the QS1 close relay activated.
2
Closing QS2
Record when the QS2 close relay activated.
3
QS1 Sync. Closing
Record when the QS1 sync. close relay activated.
4
QS2 Sync. Closing
Record when the QS2 sync. close relay activated.
5
Genset Start
Record when the genset start signal outputs.
6
S1 Genset Start
Record when the S1 genset start signal output.
7
S2 Genset Start
Record when the S2 genset start signal output.
8
Genset Stop
Record when the genset start signal deactivated.
9
S1 Genset Stop
Record when the S1 genset start signal deactivated.
10
S2 Genset Stop
Record when the S2 genset start signal deactivated.
11
Auto Mode
Record when the genset transfers to Auto Mode.
12
Manual Mode
Record when the genset transfers to Manual Mode.
13
Manual S1 Close Key
Record when operate S1 close key of front panel.
14
Manual S2 Close Key
Record when operate S2 close key of front panel.
15
Remote S1 Close Key
16
Remote S2 Close Key
