Smartgen HAT828, Руководство пользователя

Страница: 15 / 56

HAT828 High Speed ATS Controller User Manual Page 15 of 56
Table 9 – Genset Status
No. Item Description
1 Start Delay Delay time before genset start.
2 Stop Delay Delay time before genset stop.
3 Scheduled Not Run When scheduled not run is active, its duration time will be displayed.
4 Scheduled Run When scheduled run is active, its duration time will be displayed.
5 S1 Cycle Run S1 cycle run countdown will begin when cycle start is active.
6 S2 Cycle Run S2 cycle run countdown will begin when cycle start is active.
7 S1 Genset Working Active only when system has 2 gensets and S1 is generating.
8 S2 Genset Working Active only when system has 2 gensets and S2 is generating.
9 Genset Working Genset start signal output.
10 Genset Standby There is no genset start signal output.
Table 10 – Switch Status
No. Item Description
1 Ready to Transfer Switch transfer begins.
2 QS1 Closing QS1 closing delay is in progress.
3 QS2 Closing QS1 closing delay is in progress.
4 Closing QS1 Again
If “Closing Again Delay” is not 0, when the QS1 “Fail to Open”
condition occurs, it’s the delay time before the close relay is active
for the second time.
5 Closing QS2 Again
If “Closing Again Delay” is not 0, when the QS2 “Fail to Open”
condition occurs, it’s the delay time before the close relay is active
for the second time.
6 Elevator Delay Delay time before ATS transfer, elevator control outputs.
7 S1 On-load QS1 was already closed and S1 is taking load.
8 S2 On-load QS2 was already closed and S1 is taking load.
9 Off-load Load is disconnected.
Warning alarms are active when controller detects the alarm signals, and alarm indicator will
flash slowly (1 time per sec). When alarm is reset, indicator is extinguished, which means warning
alarms are not latched.
Table 11 – Warning Alarms
No. Item Description
1 Battery Under Volt.
When the battery voltage has fallen below the pre-set value, it will
initiate a warning alarm after 60s delay.
2 Battery Over Volt.
When the battery voltage has exceeded the pre-set value, it will
initiate a warning alarm after 60s delay.