SMA Sunny Island 4248U, Инструкция по установке и эксплуатации

Страница: 61 / 100

SI4248U Manual Installation Manual
53
GenOperation Auto,
Start,
Stop,
Run1h,
Release
Auto The GenOperation parameter forces the generator
to react immediately:
Auto:
Normal control by Sunny Island is active (the
display might show "G" or "*").
Start:
Generator will be started by the Sunny Island
immediately (the display will show "R"). Remember
to stop the generator when not needed anymore (by
selecting either "Stop" or "Auto").
Stop:
Generator will be stopped by the Sunny
Island immediately (the display will show "S").
Remember to set the generator back to "Auto"-
mode if you want the Sunny Island to take over con-
trol again.
Run1h:
Generator will be started immediately and
will kept running for one hour (the display will show
"T"). Afterwards the Sunny Island will switch back
to the previous mode. If "Run1h" was selected from
"Start" mode the Sunny Island will switch back to
"Start" after one hour time.
Release:
Aborts the lock time (20 min.) for the gen-
erator after a "ReversePower" failure has occurred.
VacGenMax 120 - 150
VAC
130 The VacGenMax parameter selects the maximum
AC voltage the inverter will accept from the genera-
tor. If the generator voltage is higher than this limit
when running unloaded the Sunny Island 4248U
will not connect, or, if the generator voltage
exceeds this limit while connected the Sunny Island
4248U will disconnect the generator.
VacGenMin 80 - 120
VAC
106 The VacGenMin parameter selects the minimum AC
voltage the inverter will accept from the generator.
If the generator voltage is lower than this limit when
running unloaded the Sunny Island 4248U will not
connect, or, if the generator voltage goes below this
limit while connected the Sunny Island 4248U will
disconnect the generator.
Name
Range/
Unit
Default Description