SMA Sunny Boy 6000, Руководство по установке

Страница: 25 / 90

Input Voltage Configuration
SB6000U-13:SE2506 SMA America 4-1
Section 4:
Input Voltage Configuration
Opening the Sunny Boy 6000U
Remove the six screws and lock washers that attach the cover of the SB6000U. Place the
cover, screws, and lock washers aside where they will be out of your way while you are
connecting wires and cables to the Sunny Boy.
CAUTION:
Be careful
not to misplace the screws or the lock
washers, as all six screws and lock washers are required to
ensure that the cover is grounded properly and is fully sealed
to the case. Handle the cover carefully, as even minor damage
to the cover could result in an inadequate seal between the
cover and the case, thus allowing moisture to enter the case
and damage the sensitive electronic components.
CAUTION: Do not install the SB6000U during periods of
precipitation or high humidity (>95%). Moisture trapped within
the enclosure may cause corrosion and damage to the elec-
tronic components.
Locating Internal Components
Figure 4-1 illustrates the locations of the major internal components of the SB6000U.
Refer to this illustration as needed to locate particular components.
http://www.wholesalesolar.com/inverters.html
http://www.wholesalesolar.com/inverters.html