NOTICE SM CRIMP 2000-V8.0 / Mai 2012
20
5.4
Replacing the cutting block
To dismantle the tooling, refer to chapter 5.1
Holding tooling in your left hand,
you must
now check that the sliders can easily slide up
and down inside it.
To do this, take a screwdriver and firstly push
the punch guide slider and then the punch
slider up and down. (The punch slider is
difficult to move because it is pressing the
anvil sideways. This resistance is normal).
Remove the anvil
By pushing behind, slightly slide the cutting
block.
Clean up the cutting-block location with
degreaser.
Replace the anvil.
Before re-assembling, clean up every part of
the tooling.
