Slee MCS I, Руководство по эксплуатации

Страница: 15 / 36

Manual_MCS_I_2021-10-002.00_EN.docx 15
3.5 FILL UP WITH MOUNTING MEDIA (PERTEX ®)
Open a bottle of Pertex® and put it into the designated position at
the left inside wall of the MCS I. The end of the tube has to be
placed into the bottle. With a special adaptor it can be secured
against falling out as shown on the left picture. Be sure, the end of
the tube is positioned nearly at the ground of the bottle, to ensure
an optimized gain per bottle. Before each start of operation, you
need to check the fill level of Pertex®. You should never run the
bottle completely empty, because this will bring up air into the
system, which may make the mounting media dry out and stick
inside the tubes or at least may cause air bubbles on your slides.
To prevent upcoming cleaning and flushing time or service calls
because of this, you should exchange the bottles already a while
before the level reached the critical mark. Pertex®, which has been
left in a bottle, should be kept to put into the next bottle after there
is enough space again after some time of use and to consume it
completely by this way. The fill level of the Slee Pertex® bottles is
easy visible.
3.6 EVACUATION OF THE SYSTEM
From normal operation screen change to the setup menu by pressing the „Setup“ key
and then go on into “Arm&Disp” and then “Dispenser”. This menu offers a „Cleaning“
function and a „Bubble free“ function. „Cleaning“ gives you the possibility to flush the
system with xylene. For a fill up with mounting media, you should only run “Bubble
free”, as this runs slower, to prevent the media from gas bubbles due to vacuum in the
tubing. „Bubble free“ operates a special gentle and slow fill up process and also
removes already existing air bubbles from the system by this way. While all these
functions, again make sure to have an empty „purge cap“ in the correct place!