Skytech: 7060TX SkyBridge
Rev. 9-15-20 Page 2
Turn the Skybridge upside down and slide the back cover
off using your thumbs in the direction of the arrow. This will
expose the battery compartment. Insert two (2) AAA
Alkaline batteries intoSkyBridge with the flat side against
the spring. See Figs 3 and 4.
After the batteries are installed the red LED light will flash
3-times indicating it is ready to for use. Replace the cover.
Note
: The red LED light is located under the button on the
top of the SkyBridge. See Fig. 5.
Slide
Battery
Cover
Off
AAA
+
+
-
-
AAA
Fig. 3
Removing battery cover.
Fig. 4
Battery cover removed.
CAUTION: IT IS IMPERATIVE TO READ THE
INSTRUCTIONS THOROUGHLY BEFORE
PROCEEDING. YOU NEED TO UNDERSTAND
HOW THE SYSTEM OPERATES BEFORE
ATTEMPTING TO USE SKYBRIDGE.
PREPARING SKYBRIDGE
INSTALLING BATTERIES INTO SKYBRIDGE
The term "device" discussed in this manual can be defined
as a gas fireplace or gas heater that may be turned ON/
OFF with a dry contact switch including Millivolt systems
and many electronic ignition control systems (IPI). This
device is connected to a battery powered receiver.
Purchased seperately.
A device can also be defined as an electric fireplace, lamp,
radio or most anything with a switch, that enables you to
turn that device ON or OFF. That device is connected to
the model 7015 (120VAC receiver). Purchased seperately.
The system uses Bluetooh technology and
does not
require Wi-Fi
for operation.
Using a Smartphone or Tablet, a signal is sent from the
Smartphone to the SkyBridge. SkyBridge sends a signal to
a receiver that is connected to a fireplace to turn it ON or
OFF. SkyBridge can also control 120VAC outlet receivers
(optional) to turn ON or OFF a lamp, space heater, or
similar device. See Fig. 2 on front cover.
The working range of the radio frequency (RF) is 25-feet
and the Bluetooth (BLE) range is 100-feet.
The system is capable of operating 8 individual rooms,
with 8 devices in each room and each device can be
programmed using multiple timers to turn ON or OFF a
device(s). You have the ability to rename a device, room
name or a programmed event.
BASIC OPERATION CONTINUED
Red LED
Light
Fig. 5
Red LED light under button.
Pairing
Button
Optional Available Systems For Use With SkyBridge:
Model:
7001 - Button transmitter and receiver for a dry
contact switch (i.e. gas fireplaces, gas heaters).
Model:
7015 - Button transmitter and 120VAC electric
receiver for ON/OFF devices up to 1800 Watts (i.e. electric
fireplace, lamps and viturally any plug-in type of device with
an ON/OFF switch).
Model:
4001-A - Handheld remote control and receiver for
a dry contact switch (i.e. gas fireplaces, gas heaters).
Model:
4001TH-A - Thermostat handheld remote control
and receiver for a dry contact switch (i.e. gas fireplaces,
gas heaters).
