Skytech: 7060TX SkyBridge
Rev. 9-15-20 Page 9
Federal Communication Commission Interference Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note
: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Note
: The Grantee is not responsible for any changes or modifications not expressly approved by the party responsible
for compliance. such modifications could void the user’s authority to operate the equipment.
RF Warning
The device has been evaluated to meet general RF exposure requirement. This equipment complies with FCC’s RF
radiation exposure limits set forth for an uncontrolled environment. This device and its antenna(s) must not be co-located
or conjunction with any other antenna or transmitter.
IC Warning
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
SKYBRIDGE SPECIFICATIONS
Power Source:
3 Volt DC - (2) 1.5 Volts AAA Alkaline Batteries
FCC ID No:
K9L-7060TX
Canadian IC ID No:
2439A-7060TX
Radio Frequency:
433.92MHz, 2.4GHz
Environment Temperature:
0-40ºF
Dimension:
2.55” x 1.18” (65 x 30mm)
Weight:
0.08lbs (40g)
For Technical Service, call:
U.S. INQUIRIES
(855) 498-8324 or (260) 459-1703
Skytech Products Group
9230 Conservation Way
Fort Wayne, IN 46809
Sales: (888) 672-8929
Web site: www.skytechpg.com
MANUFACTURED EXCLUSIVELY FOR SKYTECH II, INC
