01/04/2020
9/20
E_MH_Mounting_instructions_Skylux_Cintralux_Alu_25mm_fixed_parts_flat_curb
Assembly of Cintralux aluminium 25 mm
fixed parts - flat curb
1. Bottom profile end piece
First position the two bottom profile end pieces LP725 with foam sealant 8 x 10 mm onto the ends of the barrel
vault curb and only then the first flat curb lateral profile LP125.
Align profile LP725 with rope or a laser using the long side of the finished curb.
Screw the bottom profile end piece LP725 onto the curb with the screws supplied (Ø 6,5 x 50 mm with neoprene
seal) in the holes provided, each time with two brackets and with a spacing of max. 500 mm. For this, use the
screw line provided in the bottom profile end piece LP725.
Important: always use the right screws depending on the type of curb (metal screws for a metal curb, wood screws
for wood, etc.).
Measure the curb width. If this corresponds with the ordered size, 1 cm play will be provided between the curb and
the bottom profile end piece.
Aligning:
2. Lateral profile
Position the l
ateral profiles for flat curb LP125 at the location of the long sides. Lay all lateral profiles in one line
on the long side (use a rope for this).
The lateral profiles for flat curb LP125 will come at the ends on top of the bottom profiles end piece LP725. (There
is a small overlap with the profiles here.)
Aligning:
Align
the
first
lateral
profile
LP125
up
to
the
U-shape of the bottom profile end piece LP725.
Make
sure
that
the
lateral
profile
LP125
just
meets
the
PC
end
piece
retainer
sheet.
Roof cladding
Screw
LP725
Bottom profile end piece
500
Align with the ends of the finished curb
LP725
Bottom profile end piece
LP125
Lateral profile for flat curb
Align
(with play ± 1 cm)
LP125
Lateral profile for flat curb
+ foam sealant 15 x 15 mm
Screw
Ø 6,5 x 50 mm
Small profiles overlap
Screw with neoprene seal
Ø 6,5 x 50 mm
LP725
Bottom profile end piece
+ foam sealant 8 x 10 mm
Finished curb at the end of
the barrel vault
Finished curb on the long
side of the barrel vault