
DRIVE SYSTEM
Belt Guard Removal and
Installation
WARNING
NEVER operate engine:
– without shields and belt guard
securely installed
– with hood and/or side panels
opened or removed.
NEVER attempt to make adjust-
ments to moving parts while en-
gine is running.
NOTE:
Belt guard is purposely made
slightly oversize to maintain tension on
its pins and retainers preventing un-
due noise and vibration. It is important
that this tension be maintained when
reinstalling.
Remove the tether cord cap (DESS
key).
Open engine compartment LH side
panel.
Remove retaining pin.
mmo2008-007-016_a
1. Retaining pin
Lift rear portion of guard then release
from upper retaining pin and front
tabs.
When reinstalling belt guard, position
its cutaway toward front of snowmo-
bile.
Place belt guard slots over tabs.
mmo2008-007-014_a
1. Slot
2. Tab
Position top portion of belt guard over
retaining pin.
mmo2008-007-015_a
1. Retaining pin
Position rear portion of belt guard over
retainer and secure using retaining pin.
mmo2008-007-016_a
1. Retaining pin
82
______________________
Содержание MX Z TNT 600 HO E-TEC
