sitrex Action 120, Руководство по эксплуатации и обслуживанию

Страница: 33 / 44

Round Baler ACTION 120
USE AND MAINTENANCE MANUAL - 33 -
If the machine is equipped with adjustable wheels,
the pick-up height can be adjusted as follows (Pic.
24):
1- Remove the plug (A)
2- Change the position of the hole on the
adjustment rod
3- Insert the plug
The wheels can be removed to reduce the
overall width of the machine
1- Remove the plug (B)
2- Remove the pin and the wheel from its seat.
5.16 RAKE ADJUSTMENT
Pic. 25
– Rake
The rake can be adjusted in two height positions
(A and B of Pic. 25). Use the position according to
the ground height of the pick-up and the type of
product to be collected.
The adjustment stop (C) must be positioned so
that the dimension D is equal to 5 cm.
5.17 MACHINE JAMMING
During the work phase, the machine may «jam».
Should this happen, stop immediately and
proceed as follows.
WARNING
In the event the part of the machine jammed is
where the product is fed in, remember it is
strictly prohibited to clean the round baler
while it is running.
The power takeoff must first be disengaged,
the engine shut off and the parking brake
pulled on.
In order to free the machine, you must:
1. Disengage the power takeoff, stop the
tractor and pull on the parking brake.
2. Wait until all the moving parts have
stopped completely and procure a
suitable pair of cut-proof gloves.
5.18 STOPPING THE ROUND BALER
When work is finished, the operator must:
-
Stop the tractor on flat and engage the
parking brake.
- Disengage the tractor P.T.O. shaft.
- Switch off the power supply to the control unit.
- Raise the pick-up.
- Stop the engine.
- Fix the collector in a raised position and close
the tap located on the control tube.
- Drain the hydraulic circuit pressure.
- Check that the tailgate is closed and that all
the parts of the machine are completely
stopped and in rest position.
- Lower the support foot until it touches the
ground.
- Disconnect the various connections: hydraulic
hoses and electric cables.
- Withdraw the PTO shaft from the PTO shaft
on the tractor.
- Remove the plug inserted in the towing eye.
At this point it is possible to restart the tractor and
move it to another place.
5.19 PARKING
- Before putting the round baler away in its
storage shed on a suitable level surface,
make sure all the product has been unloaded.
- Rest the front support leg on the ground.
- Wedge suitable chocks under the wheels and
make sure all the guards on the machine are
in the right place.
- Stop the tractor and pull on the parking brake.
- With the tractor still and all parts completely
immobile, remove the power-takeoff shaft
from the tractor’s power takeoff.
- Set the power-takeoff shaft down on suitable
rests so that the actual shaft and its shields
are not damaged.
- Relieve the hydraulic pressure.
-
Uncouple the hydraulic system’s connecting
hoses from the tractor.
- Disconnect the power supply cables.
- Disconnect the tractor from the round baler
drawbar.
- Lubricate and grease all the points indicated,
including the chains.
WARNING
When parking the round baler, it is essential
that the machine be housed in a place that is:
- Dry;
- Sheltered from the elements;
-
Guarded or closed to deny access to
personnel not authorized in the machine’s
use.
5.20 SAFETY DEVICE
The installed security devices must be always
efficient and correctly positioned.