Siterwell GS690, Инструкция по установке и обслуживанию

Страница: 9 / 63

9
Document NO.: RD-690-39-001 Version: A Date
：
2017.12.30
2.2
Factory Default Settings
This control and indicating equipment is supplied ready to operate as a standard addressable control panel. Optional
functions and their configuration are described in following sections.
The default settings are as follows:

All alarm Zones enabled

All Input groups enabled

All Output groups enabled

All Detection Zone definitions will be cleared (no devices assigned)

All Input groups definitions will be cleared (no devices assigned)

All Output groups definitions will be cleared (no devices assigned)

Alarm Zone device delay settings will be cleared

Alarm Output groups delay settings will be cleared

User access to all programming functions will be denied

The analog loop is enabled

All initiating devices are enabled

The event log will be cleared

The
“power on” count will be set to 0

The default installation mode

Information about installed devices and their types will be cleared
2.3
Specifications
Power Supply
Operating voltage AC(110
～
220)V,50/60Hz
Mains supply Current Limit 2.1A
Mains supply fuse 4A/AC 250V slow blow(20mm)
Power supply 3.5A@28.5V
Standby battery maximum capacity (2xDC 12V) 12Ah
Maximum battery current draw 1.2A@maximum operating temperature
Charging Circuit 28V,±2% Nominal
Battery fuse 1A resettable(electronic fuse)
Battery fault threshold voltage < DC 20V
Quiescent current 100mA @ DC28.5V
Addressable Loops
Addressable loops 2
Number of connected devices per loop 127
Loop current(max) 100mA @40ohms(max) @24V DC per loop
Loop monitoring Open, short-circuit and Ground
Power Limited
Audio Alarms
Configurable audio alarm groups(max) 7