Siterwell GS690, Инструкция по установке и обслуживанию

Страница: 47 / 63

47
Document NO.: RD-690-39-001 Version: A Date
：
2017.12.30
Maximum up to 8 Main Panels can make a network group by Ethernet port.
The default status of Ethernet communication is DISABLED.
Disabled Ethernet will be indicated on the LCD and can be reviewed using
【
DISABLED
】
key.
4.3.10.6.3.2 Operation
1) By pressing the
【
3
】
key from the Commun screen enters into Ethernet mode.
2) Press the
【
UP
】
or
【
DOWN
】
key to select the status DISABLED or ENABLED.
3) If select DISABLED, press
【
ENTER
】
key to confirm the selection and it will automatically return to previous
menu.
4) If select ENABLED, it will enter into the configuration of Router IP Address, IPV4 Address, Mask Address and
Port number.
5) Press
【
ENTER
】
key to confirm the selection and it will automatically return to previous menu.
4.4 Access Level
Four access levels are used to operate or configure the control and indicating equipment.
4.4.1 Common Level
Common Level provides open access to perform the following functions:

Fire, Fault, Pre-alarm and Disable queue review.

Place the panel into User Level or Admin Level.

Perform the indicator test.
4.4.2 User Level
User Level provides access to the functions enabled during configuration at Admin Level using Menu Item. The default
setting is to deny access to functions.
Typical functions configures for User Level may include:

Common Level.

Acknowledge a new event and silence the inner buzzer.

Silence and re-active alarms (including for a building evacuation).

Reset the fire detection and alarm system.
4.4.1.1 Enter User Level
To enter User Level, undertake the following actions.
1) Press the
【
MENU
】
key. The LCD will prompt "Please Enter Code: ------".
2) Input the default User password "666666".
3) Press the
【
ENTER
】
key to confirm the password.
It will be memory as an event when entering the system by User Level.
The entry sequence of entering User Level must start within 10s and there must be no more than 10s between key
presses. If there times are exceed, the system will revert to default display.
4.4.1.2 Change User Level Password
To Change the User Level Password, use Menu Item as below.