Sinterit LISA PRO User Manual | 44
Pour the contents of the IO Box onto the Powder Chamber grid.
3. Starting with the external layers of the cake, crush it and
push the powder through the grid. Watch out for prints
inside the cake body.
4. In the end, check the amount of powder in the Powder
Chamber. You can lift the grid and, with a Powder Wiper,
clean the walls of the chamber from the powder deposited.
Do not remove the Powder Feeding Screw guard inside the
chamber!
Pour the contents of the IO Box
onto the Powder Chamber grid.
5.
The overflow of powder (or when the powder is solidified and does not sieve) and collected on the Powder Feeding
Screw guard can be pressed into the chamber with the Trowel. Only the powder below the guard will be transported
and sucked in.
6. Remember to put the grid back on the Powder Chamber.
Clean the Powder Chamber walls
from embedded powder.
Use the Trowel to push the powder through
the Powder Feeding Screw guard.
7. The extracted prints should be cleaned above the Fine Dust Chamber grid with brushes, stainless steel probes, and
spatulas, and placed on the Worktop (or on the Foldable Tray on the right - if there is no sandblaster placed there).
8.
Powder located in Overflow Bin from the printer should be poured on the Powder Chamber grid.
