Sinterit LISA PRO User Manual | 60
17. Check if anything is blocking the slide of the cord.
18. First, mount the end of the cord with the spring on it.
19. Slide the Recoater to the Feed Bed side.
20.
Mount the cord starting from the side of the Overflow Bin gap. Be sure that the spring is fitted into the hole behind the
plate.
21. Screw and tighten up the screws.
22. Pull the cord to tense the spring.
23.
Slide the Recoater to the Overflow Bin side.
24. Mount the cord using screws on the opposite side.
25. Move the Recoater and check if the rotary shaft is rolling properly.
26. Assemble the Recoater cover and screw both screws on the Recoater cover.
27.
Turn the printer (use Ignition key).
28. On the touchscreen press CONTROL PANEL//MOTORS//HOME ALL AXES.
29. Check if Recoater moving without any disturbance. Properly installed cord is moving slightly right and left on the
bearing system.
17. Packaging guide for Lisa PRO Printer
A. PREPARING LISA PRO PRINTER TO BE PACKED
1. Turn on the printer and wait until the main manu is loaded.
2. Unlock the printer’s Lid: press UNLOCK LID/OVERFLOW BIN button on the screen. Remember, you only have 10
seconds to open it before the lock activates again. Open the Lid.
3. Turn off the printer for cleaning.
4.
Clean the printer from the powder (both BEDs and the space around them, OVERFLOW BIN, RECO-ATER).
5.
Open the Heating module and remove the Laser Protective Glass. Put it in the original boc (STARTUP BOX). Secure it
with tape for transpotation.
6. Put ont the original plastic protection cap on the Laser system and mount the Heating module back to the printer’s Lid.
7. Check that the BEDs are at level with the printer housing ant the RECOATER is located between the BEDs.
8. Close the printer’s Lid.
9. Unplug the Power cable and put it in the STARTUP BOX.
10. Put the Ignition key to the STARTUP BOX.
11. Close and tape the STARTUP BOX. Place it in the service area under BEDs.
12. Unplug the Nitrogen hose from the Nitrogen inlet ipple.
13. Dismantle the Removable Front Panel.
•
Grasp the panel in the middle of its top and bottom adge. Pull the bottom adge firmly while holding to the to edge.
•
Disconnect all four Magnetic fasteners between the panel and the printer front side.
•
Hide the Removable Front Panel in the recess under the Flightcase lid.
B. PACKAGING LISA PRO PRINTER TO FLIGHTCASE
1. While holding the holders in the printer set the device on the
bottom of the Flightcase (two people needed). The stickers
on the bottom of the Flightcase will help you to position the
printer correctly. If there are no labels, note the positioning
of filler foams, especially the L-shaped foam.
IMPORTANT!
1.
By holding the four handles of the the Flightcase cover, put it on the printer (two people needed).
2. Match the cover with the bottom of the Flightcase. Look at the colours of the markings on the sides of the cover and
the bottom of the Flightcase (blue and red stickers).
3. Close the the Flightcase with 4 cover locks.
4. Place the Flightcase on the transport pallet, secure with foil and tape.
