Sinterit LISA PRO User Manual | 11
H. RATING PLACE (SPECIFICATION TAG AND SYMBOLS)
DO NOT REMOVE THIS LABEL!
Manufacurer:
SINTERIT Sp.z o.o.
ul. Nad Drwiną 10 bud. B3, 30-741 Kraków, Poland
www.sinterit.com
Name:
SINTERIT LISA PRO
Serial number:
1234597890
Manufactured:
Made in: EU, POLAND
IEC Protection Class:
Machine type::
SLS 3D PRINTER (SELECTIVE LASER SINTERING)
Class 1
Dimensions:
725 x 635 x 1020 mm
Total weight:
90 kg
Power consumption:
220-240 V AC, 50/60 Hz, 7 A, 1.9 kW
IP Code:
IP30
Max tempetature:
Internal:
210°C
External:
60°C
N
Contains devices FCC:
FCC ID: TE7WN725N
Laser product class:
CLASS 1 IR LASER PRODUCT
Embedded laser
product class:
Wavelenght:
λ = 808 nm
Beam divergence:
Θ = 10°
Beam cutput:
CW (CONTINOUS WAVE)
Maximum power:
5 W
View of the specification tag in the Sinterit Lisa PRO printer.
ATTENTION!
•
Make sure all the safety messages are legible.
•
Clean these with a cloth, soap and water. Do not use solvents, diesel fuel or petrol.
•
Replace the damaged plates with new ones supplied by Sinterit. If a plate is attached to a
replaced part, make sure a new plate is affixed to the new part.
•
When contacting the manufacturer or dealer, always quote the details shown on the printer
plate.
WARNING!
•
Removing the safety plates on the printer is strictly forbidden!
•
The manufacturer declines all liability in relation to printer safety in the event of failure to
comply with the above indications.
I. SCRAPPING
IMPORTANT!
In the case of scrapping, all the component and parts of the printer will have to be
disposed of through adequate disposal channels in accordance with applicable
legislation. Before scrapping, all plastic and rubber parts will have to be separated
from the electrical material. Parts made of plastic, aluminium and steel only may
be recycled if collected by special centres.
