Sinterit LISA PRO User Manual | 55
ATTENTION!
•
Wear individual protections.
•
Protect your face and hands.
1. To start it press: CONTROL PANEL//MORE OPTIONS//
MATERIAL CHANGE.
2.
A message will appear: „HAVE YOU CLEANED THE PRINTER
AFTER LAST USE?”
•
If the powder is in the printer and you press „NO, THE
POWDER IS STILL INSIDE” button the printer will go to
”CLEAN PRINTER” and guide you through the process of
cleaning the machine.
•
If there is no powder in the printer, press the „YES” to go
further.
BACK
YES
NO, POWDER IS STILL INSIDE
Have you cleaned the printer after the
last use?
And it is free from any remaining powder?
Check that you have cleaned the printer before.
3. The procedure is needed when you change the powder
from a lower melting point to a higher one.
BACK
NEXT
If you want to print from material with
HIGHER temperature than material used for
previous print. You must perform material
change procedure.
e.g. TPE -> PA12 Smooth
The procedure necessary when changing the powder
from a lower to a higher melting point.
4. After pressing the NEXT button, the BEDs and Recoater
homing process will start. Make sure that the way of the
Recoater is not obstructed and click the DONE button.
BACK
DONE
Positioning beds for material change
in the highest position.
Make sure that the way of the Recoater
is not obstructed
Check that the Recoater path is not obstructed.
5. Homing will end when BEDs are in the highest position and
Recoater is between the BEDs.
Print bed
•
Feed bed
•
Recoater
•
Please wait while
Recoater and Beds get positioned...
Homing......
Beds and Recoater’s positioning screen.
6. Clean the Print Chamber and all the components inside
thoroughly. We suggest using Sinterit ATEX Vacuum
Cleaner with a PVC brush or compressed air (be careful
that the powder does not rise into the air).
After cleaning everything, press the DONE button.
BACK
DONE
Clean Feed and Print Bed int the highest
position from any residue powder
Clean the Print Chamber from all remaining powder.
