Sinclair GSH ERB-3 Series, Руководство по обслуживанию

Страница: 90 / 160

86
mode; The set point should be the smaller one between “ T-Water tank ” +5°C and 60°C in “ Hot water ” mode.
2.The water pump for other thermal must be always active under the “Heat” mode.
3.Under the “
Heat ” mode, the 2-way valve will be controlled based on the setting of the control panel. During
heating operation, the water pump of the heat pump unit will be stopped; however, during standby status, the water
pump will start but the other thermal will stop.
Under the “ Hot water ” mode, the 3-way valve will switch to the water tank, the water pump of the heat pump will
always stop but the other thermal will start.
Under the “ Heat + Hot water ” mode, the other thermal only works for space heating, and the electric heater
of the water tank works for water heating. In this case, the 2-way valve is controlled base d on the setting of the
control panel, and the 3-way valve will always stop. During heating operation, the water pump of the heat pump
unit will be stopped; however, during standby status, the water pump will start.
Logic 2
1.The set point of other thermal should be equal to that of “ WOT-Heat” and both are or lower than 60
℃
in “ Heat ”
mode and “ Heat + hot water ”mode; The set point should be the smaller one between “ T-Water tank ” +5°C and
60°C in “ Hot water ” mode.
2.The water pump for other thermal must be always active under the “ Heat ” mode.
3.Under the “ Heat ” mode, the 2-way valve will be controlled based on the setting of the control panel. During
heating operation, the water pump of the heat pump unit will be stopped; however, during standby status, the water
pump will start but the other thermal will stop.
Under the “ Hot water ” mode, the 3-way valve will switch to the water tank, the water pump of the heat pump will
always stop but the other thermal will start.
Under the “ Heat + Hot water ” mode (“ Heat ” takes the priority), the other thermal only works for space heating,
and the electric heater of the water tank works for water heating. In this case, the 2-way valve is controlled base d
on the setting of the control panel, and the 3-way valve will always stop. During heating operation, the water pump
of the heat pump unit will be stopped; however, during standby status, the water pump will start.
Under the “ Heat + Hot water ” mode (“ Hot water ” takes the priority), the other thermal works for space heating
and water heating. The other thermal will work for water heating firstly, after reached “ T-water tank ”, it will trun to
space heating mode.
Logic 3
The heat pump will only send a signal to other thermal, but all the logic of control must be “ stand alone ”.
Other Thermal Control
No. Product Mode Remark Required accessories
Logic 1
Monobloc
Heat / Available RT5 temperature sensor
Hot water / Available Extra 3-way valve, water tank sensor
Heat+Hot
water
/ Available RT5 temperature sensor, water tank sensor
Split
Heat / Available RT5 temperature sensor
Hot water / Available Extra 3-way valve, water tank sensor
Heat+Hot
water
/ Available RT5 temperature sensor, water tank sensor
All in One
Heat / Available RT5 temperature sensor
Hot water / Not available /
Heat+Hot
water
/ Available RT5 temperature sensor, water tank sensor