Simplex 4007ES Panels, Руководство программиста

Страница: 25 / 168

4-3
4007ES Panel Programmer Manual ( 579-1167 )
Service
Reset Select Service Reset to allow an operator to reset the system even though
the device causing the alarm has not restored to normal.
The typical application for this would be when a malfunctioning initiating
device (detector or sensor consisting of a base and removable head) causes
an alarm, but will not reset even though the off-normal condition is no longer
present. With this option enabled, the head can be removed and the system
(including the local energy masterbox, if provided) can be reset. Without this
option enabled, removing the head will cause the system to abort the reset
because it will not have seen the alarmed point/zone having restored to a
normal state, and it will not be possible to reset the local energy masterbox.
The default setting for this option is disabled.
Combined
Alarm and
Hardware
Reset If checked, pressing the Reset button performs an alarm reset followed by a
hardware reset. If this option is not selected, an alarm reset is performed if
there are fire alarms or supervisories in the system. Otherwise, a hardware
reset is performed.
Display First
Alarm When this option is selected, the display alternates between the summary
screen (with the number of active alarms, troubles, etc.) and the screen
showing detailed information on the first alarm received by the system.
If this option is not selected, the screen indicating the number of alarm
conditions on the system is displayed.
Non Steady
Audible Evac When enabled, this option allows you to select the type of operation for Non
Steady Audible Evacuation Signals. The term Non Steady Audible Evacuation
Signal refers to any Notification Appliance capable of sounding a coded
signal. The default setting for this option is not enabled. Choices are:
•
California Code 1 . A coding pattern consisting of 12 beats within a
10 second span of time, followed by a 2 ½ second pause. This sequence
repeats four times (four rounds) and then terminates (i.e., the total coding
pattern lasts approximately one minute).
• California Code 3. Same coding pattern as California Code 1, however the
sequence repeats 12 times (12 rounds) and then terminates (i.e., the total
coding pattern lasts approximately three minutes).
• Fast March Time . A coded signal that uses 120 beats per minute. Each
beat consists of ¼ second pulse on, ¼ second off. Pattern repeats until
alarm silence.
• March Time. A coded signal that uses 60 beats per minute. Each beat
consists of ½ second pulse on, ½ second off. Pattern repeats until alarm
silence.
• Slow March Time. A coded signal that uses 20 beats per minute. Each beat
consists of 1.5 second pulse on, 1.5 second off. Pattern repeats until alarm
silence.
• Temporal 4 . A CO gas warning that is a repeated sequence of four
cycles of 100 msec on with 100 msec off, followed by 5 seconds off.
• Temporal . A three-pulse coding pattern consisting of three ½ second
pulses, each separated by a ½ second silence. Each three pulse group is
separated by 1 ½ seconds of silence. Pattern repeats until alarm silence.
• On Steady.
Note: If the coding pattern selected here is not supported by the notification appliance,
it will be replaced by a default one.
Continued on next page
Table 4-2. General System Options (Continued)
Option
Description
(“dflt” indicates the default setting)
Panel Information and Configuration, Continued
System Options