Simex SWI-94, Руководство пользователя

Страница: 37 / 56

User manual - WEIGHT METER SWI-94
”b nett”
- enable of presentation mode switching ( gross/net) - button
[ B/N ]
:
“oFF” - disabled,
“on” - enabled.
7.3.6. ” Pr inP ” parameter
This parameter allows enabling of function realised by programmable input.
”diSAbL” - disable programmable input,
” ZEro ” - use programmable input to execute zeroing function,
” tArE ” - use programmable input to execute tare function,
7.3.7. ”HOLd” menu
This menu contains parameters connected with peak detection function. See also full
description of the peak detection function in paragraph: DETECTION OF THE PEAK
VALUES
“modE” - the type of detected changes of the input signal, can be set to values:
”norm” - peaks , peak and next drop of the input signal of value equal at least
“PEA”
,
”inv”
- drops, drop and next peak of the input signal of value equal at least
“PEA”
,
“PEA” - minimal detected signal change classified as peak or drop (see Figure 6.1 )
“timE” - maximum time of displaying of the peak (drop) value, can be set from 0.0 to 19.9
sec, with 0.1 sec. resolution. If „
H diSp ”=” HOLD ” then setting parameter
"timE"
=
0.0
causes holding peak value until
[ESC]
button is pressed. If
„ H diSp ”=” rEAL ” then value "timE" = 0.0 means no holding.
“H diSp” - type of displayed values:
”rEAL”
- current value is displayed,
”HOLd” - peak (drop) value is displayed,
“H rEL1”, “H rEL2” - relay/LED outputs ( R1,R2) operation mode:
”rEAL”
- relay/LED operates depend on the current value,
”HOLd”
- relay/LED operates depend on the peak (drop) value.
”H OUtP” - current output operation mode:
”rEAL”
- current output operates depend on the current value,
”HOLd”
- current output operates depend on the peak (drop) value.
7.3.8. ”briGHt” parameter
This parameter allows user to set bright of the LED display, bright can be set to
conventional values from 1 to 8.
37