Simex SWI-94, Руководство пользователя

Страница: 29 / 56

User manual - WEIGHT METER SWI-94
7.2.3. Switch parameters (“LIST” type)
Switch parameters can be described as a sets of values (a lists) out of which only one of
the options available on the list can be selected for the given parameter. Options of switching
parameter are selected using
[^] , [v]
keys.
Short pressing of [ENTER] causes in displaying of the acknowledge question ( ”SEt?” ).
If key [ENTER] is pressed again, the changes are accepted, stored in EEPROM end the
edition process finished. Pressing the key
[ESC]
after
”SEt?”
causes in cancelling of made
changes and returning to menu.
Functions of buttons when editing numeric and switching parameters:
While editing numeric parameter:
• change of current (flashing) digit
• slide change of value (acceleration, deceleration, direction change)
While editing switch parameter - selection of switch parameter.
If numerical parameter is being edited, a short press of [ENTER] button
change edited position. A long press of [ENTER] button (at lest 2 sec.)
causes of display a
”SEt?”
ask, which allow user to make sure if change of
the parameter value is correct. If switch parameter is being edited, a short
press of
[ENTER]
button causes of display a
”SEt?”
ask. When
[ENTER]
button is pressed again (while ”SEt?” is displayed) the new value of the
parameter is stored in EEPROM memory.
Pressing this button operator can cancel the changes done up to now (if
they were not approved by
[ENTER] button after the ”SEt?” ask) and come
back to menu
7.3. MENU DESCRIPTION
“- - - -” - password checking. If some password different from „ 0000 ” is set, then every
enter to main menu follows the entering of password. If entered password is
correct then first menu position will be displayed else warning ”
Error ”, and unit
returns to measurement mode.
Due to problem with direct displaying of “
m
” letter, it is exchanged with special sign
“ “. Independently in user manual letter „
m
” is used to make it more readable
(example:
“modE”
).
7.3.1. “rELAy1” menu
This menu allows to configure the operation mode of relays and LEDs marked „ R ” (e.g. „ R1 ”).
If there are few relay outputs available, then every output has its own configuration menu
(e.g. menu
„rELAy2” for relay (LED) „ R2 ”). Principle of the relays operation is described in
paragraph 6.3. CONTROL OF THE RELAY OUTPUTS .
29
MENU
ESC
ENTER
i