Simex SWI-94, Руководство пользователя

Страница: 7 / 56

User manual - WEIGHT METER SWI-94
4.1. UNPACKING
After removing the unit from the protective packaging, check for transportation damage. Any
transportation damage must be immediately reported to the carrier. Also, write down the unit
serial number on the housing and report the damage to the manufacturer.
Attached with the unit please find:
- user’s manual,
- warranty,
- assembly brackets - 2 pieces.
4.2. ASSEMBLY
- The unit is designed for mounting inside housings (control panel, switchboard)
insuring appropriate protection against surges and interference. Metal housings
must be connected to ground in a way that complies with the governing
regulations.
- Disconnect the power supply prior to starting assembly.
- Check the connections are wired correctly prior to switching the unit on.
In order to install the unit, a 90.5 x 43 mm mounting hole ( Figure 4.1 , 4.6 ) must be
prepared. The thickness of the material of which the panel is made must not
exceed 5mm. When preparing the mounting hole take the grooves for catches
located on both sides of the housing into consideration (
Figure 4.1
,
4.6
). Place the
unit in the mounting hole inserting it from the front side of the panel, and then fix it
using the brackets (
Figure 4.3 ). The minimum distances between the centre points
of multiple units - due to the thermal and mechanical conditions of operation - are
115 mm x 67mm (
Figure 4.2 ).
Figure 4.1. Recommended mounting hole dimensions
7
!
!
90,5 mm
13 mm
8 mm
8 mm
13 mm
1 mm
max. 5 mm
4
3
m
m
1 mm