SILLA PRISM SOLAR RFID, Инструкция по установке, использованию и техническому обслуживанию

Страница: 8 / 52

Safety - Line electrical
Infringement of or failure to observe these guidelines may result in
serious injury due to electric shock, with even fatal consequences. In
addition, regular use of Prism cannot be guaranteed in the event of
infringement of these warnings.
The Prism models are designed to operate at a mains voltage of 230V (single-phase) or
400V (three-phase) 50Hz.
An adequately dimensioned mains connection must be available at the installation site.
This connection should only be provided for Prism and cannot supply other electrical
equipment. If necessary, a separate supply line must be arranged in accordance with the
general requirements on supply lines and building technology.
The cable cross-section must be adjusted in accordance with the desired connected
power and other aspects (such as line length, material, type of arrangement, etc.). The
Prism connection terminals are designed for a line with a minimum cross-section of
2.5mm2 up to 10mm2.
Prism incorporates a type B RCD (20mA AC, 6mA DC). The supply line for Prism must
always be dimensioned and secured in accordance with nationally applicable regulatory
requirements.
Prism does not have a separate on/off switch. If you want to deactivate the Prism, you
must always set the MCB switch installed upstream in the domestic installation to
position 0 (off).
In various countries, the requirements set out in this manual differ
from the connection conditions for the electricity grid local. Prism
must always be connected in accordance with the applicable
regulations for the installation location.
6 - Prism SOLAR rel. 2.2.2