SIKA FMP1, Руководство по эксплуатации

Страница: 48 / 56

Basic setting and Operating FMP1
- 48 - © SIKA • Ba_FMP1 • 03/2014
Analogue input :
You can adjust the analogue input to match the characteristics of the connected transducer.

Set the value for the characteristic of the analogue input.
Available values: "1" = 2 mV/V, "2" = 3 mV/V, "3" = 4…20 mA or 0…10 V (on request).
Analogue output :
Configuration of the analogue output starts with this parameter. First set the desired output
signal. Then you can adjust the other parameters – zero offset, full scale and amplitude – of
the analogue output to match your requirements.

Set the parameter to and confirm the entry.

Set the value for the desired output signal.
Available values:
"diS" = disabled, "Pn10" =

10 V, "0-20" = 0…20 mA , "4-20" = 4…20 mA .
Zero offset:
Use this parameter to compensate for the zero offset of the analogue output. It can be up to
30 to 50% of the full-scale value of the device.

First reset the device by pressing the ZERO key (in measuring mode) or setting the tare
parameter as described above.

Set the parameter to and confirm the entry.

Set the desired zero offset value.
Value range: 0000…9999.
Full-scale value of analogue output:
Use this parameter to change the full-scale value of the analogue output. The change is pro-
portional to the full scale value of the FMP1.

Set the parameter to and confirm the entry.

Set the desired full-scale value.
Value range: 0000…9999.
Analogue output amplitude:
Use this parameter to adjust the amplitude of the analogue output. The adjustment range is 5
to 11.5 V with voltage output or 12 to 28 mA with current output.

Load the device sufficiently to attain the desired full scale value of the analogue output.

Set the parameter to and confirm the entry.

Set the desired amplitude value.
Value range: 000.0…109.0 %.
Notice: For more precise adjustment, the final digit changes only after 10 keypresses.
Notices:

After device switch-on, the analogue output is activated only after the readout has
stabilised.

The response time of the analogue output is affected by the digital filter setting. We
recommend using a filter setting ≥ 2 for the analogue input..