User Manual
2614 Texoma Drive Denison, TX 75020 • 980 Contract St. Suite 110 Lexington, KY
Phone: 903-462-7700 or toll free 800-899-5655 • Fax: 800-966-6834
27
Menu or Key Function
Setting
Default
Blade Length
Adjust
To adjust the length of the blade
Note:
1.
Keep your blade length as 0 before you start adjusting.
2.
Test the blade holder first and then test the blade length by
pressing ENTER.
3.
Keep the blade holder at the same position when you
perform blade holder and blade length tests.
4.
When blade holder and blade length tests are finished, the
screen will show you to what degree (the unit of the value following
“CW” or “CCW” is “circle”) and in which direction [CW (clock-
wise) or CCW (counterclockwise)] you should turn the adjustment
knob. I.E. “Turn CW 0.5” means you should turn the knob clock-
wise one half turn.
5.
The value on the screen will be 0.0 when the blade length
is perfect and no more adjustment needs to be made. You may start
cutting at this point.
0.00mm-5.00mm
0.00mm
[ DATA CLEAR ]
To clear buffer memory.
[ TOOL SELECT ]
Set Smoothing
Cut
To enable smooth-cutting function.
Enable
Over Cut
To generate an overcut to facilitate weeding.
0.00mm-1.00mm
0.05mm/per step
0.00mm
Set Tangential
Mode
To enable the emulated tangential-cutting mode for thicker media
types and small letter cuts.
Note: If the Offset value is set at 0.000 mm, “Set Tangential Mode”
will automatically be disabled.
Disable
Panel Setup
Accept setup command:
To accept commands of the Force, Speed, Cutting Quality, and
Offset only from software.
Control panel only:
To accept commands of the Force, Speed, Cutting Quality, and
Offset only from the control panel of the cutter.
Restore Default
To return all parameters of the menu items to factory-default
settings.
Continued Next Page...
3.4 Menu Items Cont’d
