User Manual
2614 Texoma Drive Denison, TX 75020 • 980 Contract St. Suite 110 Lexington, KY
Phone: 903-462-7700 or toll free 800-899-5655 • Fax: 800-966-6834
14
2.4 Cable Connectioins
The EnduraCUT 2 communicates with a computer through USB (Universal Serial Bus) or Serial port
(RS-232C). This chapter shows you how to connect the cutting plotter to a host computer and how
to set up the computer/cutting plotter interconnection.
NOTE!
When the USB connection is enabled, the serial port is automatically disabled.
Figure 2-12
USB Port
Serial Port
2.5.1 USB Driver Installation
EnduraCUT 2 built-in USB interface is based on the Universal Serial Bus Specifications Revision 1.1
(Not compatible with Windows 95 Windows NT Operating Systems ).
NOTE!
If you are using Windows 2000 ,Vista, 7 or 8 as your operating system, make sure you log in as
an “Administrator”when installing the USB driver.
Administrative privileges are required.
If you have difficulty installing the USB driver, you may need to temporarily disable or uninstall
anti-virus software. Once the USB driver installation is complete, reactivate or reinstall your
anti-virus software. and make sure it recognize the new driver as an approved device
Use the USB One-click Installation for quick driver installation. Follow the simple steps below for
driver setup.