SIGLENT TECHNOLOGIES SDS2000X-E Series, Руководство пользователя

Страница: 217 / 222

SIG L ENT
SDS2000X-E User Manual
191
Figure 110 Bode plot configure menu
1) Press AWG softkey to enter AWG menu.

Press Amplitude softkey ( Offset softkey), and then turn the Universal
Knob to select the desired value or press the Universal Knob to enter the
value by the pop-up keyboard.

Press
Unit
softkey and then turn the
Universal Knob
to select the desired
unit. There are six types: Vpp, Vrms, dBV, dBu, dBm, Arbitrary dB. When the
unit type is dB, there will be a reference level setting.

Press Load softkey then press the softkey multiple times to switch the load
value between 50 Ω, 75 Ω, 600 Ω, Hi-Z, or turn the Universal Knob to
select the desired value or press the
Universal Knob
to enter the value by
the pop-up keyboard. The dBu is only available when the load impedance is
specified as 600 ohms.
2) Press AWG I/O softkey to enter AWG I/O menu.

Press Type softkey; then; turn the Universal Knob to select the desired
type.
USB
Connect the oscilloscope USB Host to the external AWG’s
USB Device via a USB cable.
LAN
Connect the oscilloscope and the external AWG to your
local area network.

If LAN is selected, press IP softkey, a dialog box named “IP” will pop up;
then; turn the
Universal Knob
to enter the value. The IP is the external
AWG’s IP.

Press Test Connection softkey to check the connection.
3) Press Sweep softkey to enter Sweep menu.

Linear mode, this mode provides parameter: center frequency and span
frequency.

Logarithmic mode, this mode provides parameter: start frequency and stop
frequency.

Press Resolution softkey; then; turn the Universal Knob to select the type.
There are three resolution levels: Low, Medium, and High.
Low Resolution = 21 data points/sweep
Medium Resolution = 101 data points/sweep
High Resolution = 501 data points/sweep
4) Press
Channel softkey to enter Channel menu. Press DUT Input softkey to
choose the oscilloscope’s channel which connects to the DUT input. Press
DUT
Output1 softkey to choose the oscilloscope’s channel which connects to the
DUT output.