AirPrime WP8548 / WP75xx / WP76xx / WP77xx AT Command Reference
232
Proprietary and Confidential - Contents subject to change
4118047
!SARINTGPIOMODE
Set/report default pull mode for SAR interrupt GPIOs
Set or report the default pull mode (high/low) for SAR interrupt GPIOs. This setting applies to
all SAR interrupt GPIOs.
Supporting devices:
WP76xx/WP77xx; WPx5xx (Release 16+)
Password required:
Yes (see
for details)
Usage:
•
Execution:
AT!SARINTGPIOMODE=<mode>
Response:
OK
Purpose:
Set the default pull mode for all SAR interrupt GPIOs.
•
Query:
AT!SARINTGPIOMODE?
Response:
<mode>
OK
Purpose:
Indicate the default pull mode.
•
Query list:
AT!SARINTGPIOMODE=?
Purpose:
Display valid execution format and parameter values.
Parameters:
<mode> (SAR GPIO interrupt pull mode default setting)
•
0=Standard mode—Default pull is HIGH/DAL_GPIO_PULL_UP
•
1=Inverse mode—Default pull is LOW/DAL_GPIO_PULL_DOWN
!SARSTATE
Set/report SAR backoff state
Set or report the current SAR (Specific Absorption Rate) backoff state.
Note: This setting is not persistent. To change the default backoff state (persistent), use
!SARSTATEDFLT.
Password required:
No
Persistent across power cycles:
No
Usage:
•
Execution:
AT!SARSTATE=<state>
Response:
OK
Purpose:
Temporarily set the SAR backoff state.
•
Query:
AT!SARSTATE?
Response:
!SARSTATE: <state>
OK
Purpose:
Indicate the current SAR backoff state.
•
Query list:
AT!SARSTATE=?
Purpose:
Display valid execution format and parameter values.
Parameters:
<state> (SAR backoff state)
•
0=No backoff
•
1–8=Backoff state 1 to 8
Table 11-2: SAR Backoff and Thermal Control Command Details (Continued)
Command
Description
Содержание AirPrime WP75 Series
Страница 1: ...AirPrime WP8548 WP75xx WP76xx WP77xx AT Command Reference 4118047 Rev 6...
Страница 2: ......
